Instructions:Surface must be completely clean and dry. Remove all dirt, paint, efflorescence, oil, loose debris and previous coatings. Prior to application, apply a few drops of the sealer to the surface. It should penetrate right away otherwise additional cleaning is necessary. Use protective sheeting to cover nearby painted surfaces, vehicles, glass and any non-masonry or non-concrete surface. For paver applications, be sure sand is filled in joints to the required level slightly below the top of the pavers. Pavers can be treated right away. New concrete should cure for 14 days and tuckpointing should cure for 3 days. Always do a small test to ensure desired look and performance of the sealer. Apply product uniformly with a pump-up sprayer, roller or use low pressure spray equipment, about 15 psi. Use a large fan type spray nozzle and apply enough material to flood coat the surface and the surface should stay wet for at least three minutes. Vertical surfaces should have a 5” rundown below the spray pattern. Broom out puddles and wipe up excess material that does not penetrate. Product will dry to the touch in typically 30-45 minutes depending on temperature. Keep traffic off for 24 hours. Do not apply if rain is expected within 12 hours.
Technical Data: Appearance: Milky white liquid
Specific Gravity: 1.00
Weight/gallon: 8.14 lbs
Freezing Point: 35 degrees F
VOC Content: Less than 100 g/L, Meets VOC requirements
Limitations: Do not leave excess or pooled material on the surface. Do not apply product to a damp surface. Protect glass, vehicles, etc from overspray. The minimum application temperature is 45 degrees F and 45 degrees should be maintained for the next 24 hours. The maximum application surface temperature is 110 degrees F. In hot weather it is recommended that product be applied in cooler morning hours. Surfaces may darken slightly during an application depending upon porosity of the surface. Do not apply to glass.
Shelf Life: Two years in unopened containers. Do not allow stored product to freeze since it is water based.
Coverage: Concrete pavers: 100-125 sq ft /gal, concrete: 100-125 sq ft /gal,
masonry & stone: 100- 300 sq ft /gal
Coverage rate will depend on texture and porosity if the surface.
Clean Up:Clean equipment with water before product dries.
Warning: Rinse immediately off of glass. Skin or eye contact may cause irritation. If eye contact occurs, flush will water. For skin contact, wash with soap and water.
Use safety glasses and wear gloves with protective clothing. Provide adequate ventilation. For exterior applications only. Do not swallow. See MSDS for complete information.
For industrial use only. Keep out of reach of children.
Cure Time:Product will dry to the touch in typically 30-45 minutes depending on temperature. Keep traffic off for 24 hours.
Packaging: One gallon units (6/case), five gallon pails and 55 gallon drums